20Ah Pro Power Kit

20Ah Pro Power Kit Trash Nocqua Patented
Nocqua 20Ah Pro Power Kit Trash
20Ah Pro Power Kit Trash by Nocqua

$199.99

You asked for it, and you got it. 20Ah of POWER that still fits within the palm of your hand. Mic drop!

20Ah Pro Power Kit Includes:

  • 12V 20Ah Nocqua Battery with Ballistic Nylon Camo Sleeve
  • 5A Pro Battery Charger with Battery Level Indicator (5A Charger cannot be used to charge 4.4Ah or 10Ah Battery)
  • Waterproof Connectors
  • Component Cable for connecting the battery to your 12V electronic device
  • Heat shrink butt connectors and heat shrink tubing
  • Awesome customer service

 

 

Add to Wishlist
Compare
SKU: 2121 Categories: ,

Specs

  • Compact design: 3.75″ x 3.30” x 3”
  • Weight 2.1 lbs
  • Dual Circuit Board Protected
  • Water-resistant design
  • 12 month limited warranty

Installation

NOCQUA Pro Power Kit Installation Instructions

Before installation and use:

  1. Confirm component requirements are compatible with NOCQUA 12V battery.
  2. Ensure that the battery is fully charged before use.
  3. Make note of the positive (red) and negative (black) wire leads before beginning installation.

Subscribe to NOCQUA Adventure Gear on YouTube for Installation Videos and Instructions

Installation of heat shrink butt connectors:

  1. Strip outer protective black insulation to approximately 1”
    • a. Be careful not to strip wire leads.
  2. Strip the individual inside wire leads to approximately 1/4”.
  3. Repeat this process for the wiring of your electronic component device.
  4. Measure and cut heat shrink tubing to 3” or to your specifications to safely seal both butt connectors.
    • a. The tubing will be heated to seal the two butt connectors at the end of installation.
    • b. The remaining tubing is additional material and can be used for future projects.
  5. Slide measured piece of heat shrink tubing over the component wire leaving room to work.
  6. Slide a stripped Pro Power Kit wire lead into the crimp barrel of one butt connector.
  7. Slide the same color lead from the component wire into the opposite side of the butt connector.
    • a. Ensure that sufficient amount of the stripped wire is secured within the crimp barrel.
  8. Using a wire stripper or a standard set of pliers, compress the crimp barrel onto the exposed wire leads.
    • a. Confirm that the crimp holds for a tight fit before moving on to the next step.
  9. Heat the connector evenly from the center out to the ends until the tubing is fully recovered and secure – do not isolate the heat in one place for too long.
    • a. Do not hold the heat directly on tubing – continually move and turn.
  10. Let the connection cool before moving on to the next step.
  11. Redo Steps #5 through #10 for the remaining wire leads.

Installation of heat shrink tubing:

  1. Slide the heat shrink tubing over the two cooled butt connectors.
  2. Carefully push until centered so that there are no wire leads showing.
  3. Heat evenly from the center out to the ends until the tubing is fully recovered and secure – do not isolate heat too long in one place.
  4. Confirm that the connectors have held during installation.
  5. Power up your gear!

NOCQUA is not liable for damage to battery or equipment

Related products