$335.99
Why settle for one Nocqua battery when you can double the battery power with this awesome deal? ! Connect two of our ultra-lightweight 20Ah 12V Nocqua lithium-ion rechargeable batteries using the Parallel Y to increase the total amp hour output
WHAT’S INCLUDED IN THE BUNDLE:
- 1 x 20Ah Pro Power Kit (kit includes 12V 20Ah Nocqua lithium-ion rechargeable battery, 5A Pro Charger and Universal Component Cable with Waterproof Connector and open leads)
- 1 x 20Ah Battery
- 1 x Parallel Y Adapter
About This Item
- The Nocqua Double Amp Hour Bundle is perfect for those electronic devices that have a higher amp draw and require a higher amp hour battery output.
- Now, you can connect two of the 20Ah batteries to increase total amp hour output.
- Nocqua batteries are compatible with Raymarine, Garmin, Lowrance, Humminbird, Action Sports Cameras, and more. Our Nocqua Double Amp Hour Bundle is the ideal companion for any marine or outdoor adventure.
- Here’s how you will determine the estimated run time of Nocqua batteries with your 12V device:
Once you have the power draw of the device in Ah you can divide that by the capacity of the battery, which will give you the run time (in hours).
Installation
NOCQUA Pro Power Kit Installation Instructions
Before installation and use:
- Confirm component requirements are compatible with NOCQUA 12V battery.
- Ensure that the battery is fully charged before use.
- Make note of the positive (red) and negative (black) wire leads before beginning installation.
Subscribe to NOCQUA Adventure Gear on YouTube for Installation Videos and Instructions
Installation of heat shrink butt connectors:
- Strip outer protective black insulation to approximately 1”
- a. Be careful not to strip wire leads.
- Strip the individual inside wire leads to approximately 1/4”.
- Repeat this process for the wiring of your electronic component device.
- Measure and cut heat shrink tubing to 3” or to your specifications to safely seal both butt connectors.
- a. The tubing will be heated to seal the two butt connectors at the end of installation.
- b. The remaining tubing is additional material and can be used for future projects.
- Slide measured piece of heat shrink tubing over the component wire leaving room to work.
- Slide a stripped Pro Power Kit wire lead into the crimp barrel of one butt connector.
- Slide the same color lead from the component wire into the opposite side of the butt connector.
- a. Ensure that sufficient amount of the stripped wire is secured within the crimp barrel.
- Using a wire stripper or a standard set of pliers, compress the crimp barrel onto the exposed wire leads.
- a. Confirm that the crimp holds for a tight fit before moving on to the next step.
- Heat the connector evenly from the center out to the ends until the tubing is fully recovered and secure – do not isolate the heat in one place for too long.
- a. Do not hold the heat directly on tubing – continually move and turn.
- Let the connection cool before moving on to the next step.
- Redo Steps #5 through #10 for the remaining wire leads.
Installation of heat shrink tubing:
- Slide the heat shrink tubing over the two cooled butt connectors.
- Carefully push until centered so that there are no wire leads showing.
- Heat evenly from the center out to the ends until the tubing is fully recovered and secure – do not isolate heat too long in one place.
- Confirm that the connectors have held during installation.
- Power up your gear!
